Romex to your amp?

@buckhorn_cortez. I think you should re-read my prior post, you are adding words/points in there that I did not state.
Nonetheless, we are in agreement on the basics.

Notice that Nordost`s top pc`s are solid core, not single core though but 6-7 conductors. Wery close to the famous pc Electrocompaniet came up with in the 80`s wich lead me to try out the nowegian 12awg Romex-equivalent. 

I am an Electrian and for each of my two systems I ran two dedicated 120V 20 amp isolated ground lines. Providing me with 80% of 40amps at each location. I use hospital grade isolated ground receptacles. I make my power cords with 12-3 SJ cord to minimal lenth using hubble connectors and they are all plugged into a power conditioner that in my opinion makes the most difference, for those that do not know isolated ground means that the ground is connected back at the panel and nowhere in between. This reduces interference from RF noise. The isolated ground and the power conditioner is all you need, IMHO, though others may differ. By the way I dont know of any Electrician that will run a dedicated line from your equipment to your panel for $200.

1. @ cerberus79,

Just curious why did you use IG receptacles. What type of branch circuit wiring/wiring method did you use for the two dedicated branch circuits?

Example
NM
MC
Metallic conduit/single conductors

Jim

@jea48 

I use IG receptacles because they keep the ground isolated, are of better quality, reduce RF. These are used in IT instalations and for medical equipment in hospitals. My runs are 12-2 solid NM wire bonded at the panel and the outlet only. I am very happy with the results.