Looking for Help with Speaker Jumper Cable Choice

High Fidelity level 2 jumpers replaced my  Transparent Reference xl jumpers.

I went to solder the high frequency leads directly to the low frequency binding posts last night and found the wires are terminated with a female flat spade connector which slides onto the male spade tab that is clamped/nutted to each binding post.  I'm not inclined to cut and solder the leads on.  

High Fidelity jumpers are out of my price range but thank you for the recommendation.  I actually stopped into their shop in TX last March to look at some used speakers they were selling.  They have some nice equipment and are very nice people.  

As Mitch2 suggested, I have already tested the speaker cables connected to the low frequency posts versus the high frequency posts.  It sounds better connected to the low frequency posts.  I haven't tried positive to low and negative to high and vice versa and will give that a shot.  

My goals were twofold with my original post.  
1. upgrade the jumpers
2. obtain jumpers with spade on one end and banana on the other.  

It sounds like I just need to find four decent banana plugs and replace one spade end with a banana on my current jumpers.  

I went to solder the high frequency leads directly to the low frequency binding posts last night and found the wires are terminated with a female flat spade connector which slides onto the male spade tab that is clamped/nutted to each binding post. I'm not inclined to cut and solder the leads on.

So you found out they used the cheapest fastest crappiest connector and want to leave it that way, in order to spend more money on the best wire in order to have it connected to the crappiest sounding connector. Is that right?

Are you sure?

I have yet to see one of these things that couldn't be removed by pushing a nice sharp pick into the crimp and prying it open. With the wire out you solder it and then if you want to keep the crappy connector for the next guy tape it inside there somewhere.

Just realize you're looking at a situation that for absolute dead certain could be improved more with some Total Contact on the connectors than you could ever get from any jumper. 

Once again I am amazed at how cheap parts are used in expensive components. Mods rule.

"But I lie awake at night worrying whether jumpers are directional."  
Agon needs a "like" tag option on posts like other forums offer.  I like your comment.  

As for going for some JPS jumpers, I struggle with spending $400 on a set when the cables cost half that.  

MillerCarbon - I'm totally capable of cutting off the female spades and stripping and soldering the wires direct to the male spades of the clamp tabs.  So far in this hobby I have not been a "modifier" other than trying different cables to optimize the sound so it didn't cross my mind.  These speakers were a craigslist scratch and dent purchase so it's not like I'd be compromising them any more than some of the scars they already have.  

I'll lie awake for a night or two pondering cutting and soldering direct and report back if I decide to take this approach.