DIY. Whose speakers would you use?

Most audiophiles are aware of the varying degrees of "good".

I agree with Dan_ed. I own Gr's N2X monitors and couldn't be happier.

If you are going to build a speaker, you should go all the way. You would begin by auditioning top favorite speakers with your favorite CD's in hand, next you would carefully note which speakers you liked best and why.

The place you buy parts for this project may have an engineer on staff. He will aid in getting the best sound for you and your music, after you give him the results you derived from speaker auditions. This speaker should be the same as a custom pair of shoes for your feet only; this speaker should be for your ears only.

>If you could pick and choose from any parts out there, which tweeters mids and woofers would you spec for a DIY set of speakers? What about the crossover electronics? Which caps, etc? Crossovers to be internal. Amps SS.

Whatever an experienced and respected designer specified.

Apart from maximum SPL and bass extension there's surprisingly little difference between drivers once you get a properly executed cross-over and uniform polar response.

Without that you can spend as much as you want on drivers (I was not impressed with the $40,000 Feastrex field coil full-range units and have heard a few bad speakers pairing an expensive RAAL ribbon tweeter to a mid-range that was too large) and the results will be mediocre.

I assembled the speakers in my bedroom from a kit. I do not believe there is any kit suitable for the "main room". It's all about "relativity".