DIY. Whose speakers would you use?

>If you could pick and choose from any parts out there, which tweeters mids and woofers would you spec for a DIY set of speakers? What about the crossover electronics? Which caps, etc? Crossovers to be internal. Amps SS.

Whatever an experienced and respected designer specified.

Apart from maximum SPL and bass extension there's surprisingly little difference between drivers once you get a properly executed cross-over and uniform polar response.

Without that you can spend as much as you want on drivers (I was not impressed with the $40,000 Feastrex field coil full-range units and have heard a few bad speakers pairing an expensive RAAL ribbon tweeter to a mid-range that was too large) and the results will be mediocre.

I assembled the speakers in my bedroom from a kit. I do not believe there is any kit suitable for the "main room". It's all about "relativity".

hi edge
Yes,Chris at Solen has helped me out alot.Being the only North American distributor for Volt and ATC drivers,he knows what the driver should do and where to cross it for your goal.I have owned $20,000 PMC MB2's,$15,000 IB2's and $10,000 IB1's and I will give them the tip of the hat but I get close enough for what my goal is for alot less $$$,but thats me.
DIY is all about your goal,dont forget.
For example
If I want hi fidelity
120-127db this would cost you between $20,000 to $75,000
110-119db $10-$20,000
90-109db $3000- $10,000
DIY is much less and can be fun(and frustrating).But its your work and pride that is satisfied.
Contact Chris at Solen Canada and tell him I sent you(LOL)and he will set you on a good path.

"I do not believe there is any kit suitable for the "main room".

Check back with this thread from time to time. I think you may have reason to change your mind. :)
Hint: www.montanaloudspeakers.com

Orpheus, you can take "audiophile" and shove it up your attitude. Most audiophiles like you only know what they are told sounds good.