2. speakers
  3. 1391766379

No binding post a good idea?

Hi.
I want to ask your opinion about my "No binding post" idea. I think the binding post degrades the quality of signal and sound very much because the post is made of one of larger metal in the signal chain. If a speaker cable from an amp is directly connected to speaker's internal wire, the signal will be purer. I have a design (pat. pend.) for a binding post without the metal connection bar. Do you think the sound will be better? What should I consider a relation to the sound with NBP?

My initial test was very positive. I'd like know your opinion before I invest money on this project. I appreciate your help in advance!
mihorn
ctsooner
2,480 posts
 
What are the measurements that say your's is best?  That's quite a bold statement.  

I know a few designers who have actually sat down and listened to many different binding posts, terminals etc..  They have hard wired as their reference.  A couple have gone with the new teflon barrier strips with gold plated screws. Some use the WBT's and some use Cardas.  

Those are the three different binding methods of those I know who have actually gone through this process.  

Bottom line is that this is only for the DIY crowd and that's cool and a blast for those who like to tinker.  It's all part of a fun hobby.
acomm
1 posts
 
I made my own binding posts using single crystal copper, and the sound is much better comparing to regular copper gold plated. Next thing I will do is to make spade plugs.
bdp24's avatar
bdp24
9,816 posts
 
The closest thing to a direct connection that I’m aware of is the Electra Cable Tube Connectors, marketed by GR Research and shown on their website. But integral to the design is the connector that must be installed on the ends of the speaker cable, in place of spades or banana plugs.
More to discover