JSS49, answering #1; yes that has been my experience with manual biasing designs, "tube drift"
Tube amplifier bias current question...
My amp is lovely, older Audio Research VT-60 - running a pair of KT88’s for each channel - into ProAcs.
About 8 months ago I had a tech look over the amp (it checked out fine) and he installed new input/driver tubes as well as a new set of Gold Lion reissue KT88s (2 matched pair). I ran an 6550’s before that...
Amp is working great, sounding great.
Today, partly out of boredom given the CV shutdown, I decided to check the power tube bias current/voltage. (The VT-60 has user adjustable bias using a multimeter across a bias resistor, with target bias voltage @ 65 mv DC across the resistor). Amp was properly warmed up and connected to speaker load. What I saw was one channel (L) the voltage had crept up to 70 mv, and other (R) was 82 mv. (I of course trimmed the voltage back down to the target 65 mv number.)
1. It is normal for bias voltages to creep up as power tubes age? i.e. the power tubes suck more bias current as they operate over time, all else equal?
2. Should I be alarmed that the creep up in bias current through one pair of the tubes is so much higher than the other? The amp has been running like this for months, are the tubes on the higher current side likely to burn out much faster?
Thanks in advance for any thoughts.
About 8 months ago I had a tech look over the amp (it checked out fine) and he installed new input/driver tubes as well as a new set of Gold Lion reissue KT88s (2 matched pair). I ran an 6550’s before that...
Amp is working great, sounding great.
Today, partly out of boredom given the CV shutdown, I decided to check the power tube bias current/voltage. (The VT-60 has user adjustable bias using a multimeter across a bias resistor, with target bias voltage @ 65 mv DC across the resistor). Amp was properly warmed up and connected to speaker load. What I saw was one channel (L) the voltage had crept up to 70 mv, and other (R) was 82 mv. (I of course trimmed the voltage back down to the target 65 mv number.)
1. It is normal for bias voltages to creep up as power tubes age? i.e. the power tubes suck more bias current as they operate over time, all else equal?
2. Should I be alarmed that the creep up in bias current through one pair of the tubes is so much higher than the other? The amp has been running like this for months, are the tubes on the higher current side likely to burn out much faster?
Thanks in advance for any thoughts.
- ...
- 5 posts total
- 5 posts total