Thank you very much Al!
Herron VTPH-2 MC Loading Plugs
During this period of social distancing, I thought I would take the time and build a few loading resistors for my Herron phono stage. A couple of questions.
1) Do I merely solder a resistor between the center pin and ground of the rca plug?
2) If I want a 100 ohm load, do I simply purchase a 100 ohm resistor?
3) Other than the resistance value, what other resistor parameters should I look for? i.e. 5w, 10w , 1% tolerance etc
4) Will the type/manufacture/quality of resistor matter? Is the resistor in the signal path?
5) Does the quality of the rca plug matter?
6) Any other suggestion?
1) Do I merely solder a resistor between the center pin and ground of the rca plug?
2) If I want a 100 ohm load, do I simply purchase a 100 ohm resistor?
3) Other than the resistance value, what other resistor parameters should I look for? i.e. 5w, 10w , 1% tolerance etc
4) Will the type/manufacture/quality of resistor matter? Is the resistor in the signal path?
5) Does the quality of the rca plug matter?
6) Any other suggestion?
- ...
- 4 posts total
- 4 posts total