2. cables
  3. 155295-46

Adding shielding to existing cables

So I have some interconnects that are picking up all sorts of RFi. I know this for two reasons, one, as I move them around the noisy/buzz sound changes, and two, when I switch them out for shielded interconnects the noise goes away.

so, I bought some tinned copper shielding and some new RCA plugs. I’m going to cut the existing RCA plugs off the existing cable and install the new shielding and new plugs. The thing is the new plugs have a plastic body so there is nowhere to easily connect the shielding to ground.

I was thinking of running a pigtail from the shielding and attachIng an eyelet to ground it to my preamp since there is a grounding lug. Would this work or is there a better way given what I intend to use?


last_lemming
Ag insider logo xs@2x
cleeds
6,012 posts
 
scroydon
... you mention "skin effect" in the following page on Helix structure for speaker wire or ICs.I have read that skin effect is a component of AC current, not DC. How is it a challenge here?
An audio signal is AC.
geoffkait's avatar
geoffkait
23,365 posts
 
OK, I’ll say it again. The voltage and current in a DC or AC circuit do not (rpt not) have frequency as a component or characteristic. The alternating frequency is not the same thing as frequency of the signal traveling through wire.
scroydon's avatar
scroydon
25 posts
 
Thanks guys. I guess I need to find an audio primer. Is there an Audio For Dummies?🤔

I was under the mistaken belief that speaker terminals and whatnot labelled positive and negative meant DC. 😶

geoffkait's avatar
geoffkait
23,365 posts
 
Oh, geez... 🙄 
Post removed 
More to discover