2. amps-preamps
  3. 156741-122106

Repair help please

Hi everyone,

I bought a refurbished Dayton Audio SA 1000 subwoofer amp that I hope is worth fixing.

After a few weeks, it started to cause a pop sound at volume levels approaching moderate and above.

A few weeks later, I noticed it happening more often when raising the volume from a lower (low enough to speak to someone in the room) to moderate level.

The unit also developed a noticeable mechanical hum and made the subs pop quite loud the last 2 times when powered off.

Parts Express reimbursed me with no need to ship mine back as they can't do anything with refurbished returns.

Duke at Audio Kinesis immediately shipped me a brand new replacement before I had a chance to send him a check!
Beginning to think the worst part of missing Axpona is not having the opportunity to meet Duke in person!

So I have a working Dayton now.
Such a nice amp!  Would be great to have the other one repaired.

Anyone else experience this? Is it worth fixing?  

System:
Laptop ->USB -> Hegel H190 ->RCA->Dayton SA1000 -> 4 subs in Series/Parallel 



  
hleeid
millercarbon's avatar
millercarbon
12,531 posts
 
First I notice series/parallel. Are you sure of the resulting impedance?

hleeid OP
219 posts
 
I connected the subs as indicated by Duke:

Dayton Right  (Top posts) output -> 4 post sub -> 2 post sub
Dayton Left  (Bottom posts)  output -> 4 post sub -> 2 post sub

Should be at 4 ohms.

Dayton user manual page 3:
8. Speaker Outputs
Speaker level output connections carry the amplified signal
to the subwoofer drivers. Binding posts will accept bare wire,
banana plugs, or spade plugs. Two sets of outputs are provided
so multiple systems can be connected. When using
both outputs the combined load must have a minimum of 4
ohms impedance!

Should the impedance be different? 
millercarbon's avatar
millercarbon
12,531 posts
 
Without knowing the impedance of your subs the only indication its right is you did what Duke said. It was kind of a long shot anyway as if they were wired for too low impedance the protective circuits would have been tripping right away not after a few weeks. 

I would open it up, look around inside, hope to find something obviously scorched or whatever. Then maybe call some place local. Because as soon as you add in shipping, labor, its really only a $500 amp so where's the value?

Main value I can see is using it as an experiment. Pull some obvious parts, caps or whatever, check values, and if everything that comes out measures good keep it out, put in a bag, you saved what you could, toss the rest.
More to discover