Stillpoint component stand with Verity Parsifals

Not cheap indeed. I presume they are a step up from the component stands which are starting to appear for sale on Audgion?

When all is said and done the ultra work out cheaper as the component stands, and are supposed to outperform them. Aestetically, the ultras also have a leg up

Quick followup question on mechanics -- for the ultras, do you remove the stock brass footers from the Parsifal (assume they screw off?) and replace them, or do you (could one) effectively install the ultras into the stock brass footers, screwing them into where the stock spikes live? (Might look a bit silly with stacked footers, but curious). Also, am I correct in assuming that, with the ultras, you can still thread them at different levels in order to level the speakers (dealing with an uneven floor, so important in my case, and also am growing to appreciate a slight forward tilt that, as I saw suggested here, actually raises the soundstage pretty effectively).

I currently have them on the stock spikes, and the spikes then into (onto) granite blocks on furniture slider pads. Very less than ideal, but my setup requires that I move them all the time -- lets just say that day-to-day use of that end of the room and ideal listening placement look rather different. All in all, practical if not relatively effective. But always on the lookout for improvements. Many thanks.

You take off the brass spikes and screw on the ultra's. The ultra's themselves have a hardhat screwed on allowing you to level the speaker.

Thanks. Hadn't undertaken to actually upended the things to confirm the brass cones in fact come off. If you don't mind another question, how much travel (for lack of a better word) do you get with the stillpoints? Like the stock brass cones / steel spikes because you can get near a full inch between the front and back spikes, and on one corner I unfortunately am close to needing that much...(ok, some exaggeration, but not as much as I might like). Thanks again.