Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

Has anyone tried a Valvet amp with a Nenuphar?

@rwpollock   I've had an interest in Valvet for some time and came close to purchasing the A4 instead of my Pass Labs 30.8 to drive my previous speakers.

I just took a quick look at Valvet's website but couldn't find the information I was looking for.

I recommend reaching out to Alfred (the importer/retailer) and Valvet directly to find out the following:

- Feedback (preferably zero; or very low levels)

- Damping Factor (the lower the better)

If the above holds, I can see Valvet being an alternative along the lines of First Watt, which (as you probably know) has proven to be a terrific pairing with the Nenuphars.

I've sent an e-mail to Alfred at Highend-Electronics. Will let you know what he replies.
 - Robert

Reference coupling to Townshend Podiums. This is a good thing I believe but difficult to achieve in practice. At the moment I have only gone as far as fixing down the cups with industrial double sided tape to the Podiums to stop sliding. It also means I can change from 10 to 8 inch Nenuphar’s using the same Podiums by detaching the cups and repositioning.

Any material change under the speakers ( or under any piece of equipment for that matter) will change the sound of course. If I were to make new block feet, out of wood for example, then I would make use of the existing threaded inserts in the speaker bottom and fix them using counterbored threaded bolts. The feet would then be fixed to the Podiums with DS tape or even better ( but more extreme) drilling a hole and fixing with screws from under the top plate. Candidates for best feet material: perhaps Maple, Ebony, brass?

Regarding amplification compatibly with the Nenuphar’s I just want to emphasis that the little (but giant in performance) Bakoon 13R should be added to the list of suitable amps imo.

RY, you know the solution: Nenuphar BASiS. Sealed cabinet. Full Metal (Jacket) Contact. : )