Is the entire plastic pin gone?
Broken plastic guide on tubes - how to tell which way the tube fits in socket?
I have a few tubes (and also a set of 6SN7>6F8G tube converters) where the plastic "guide" with the notch that tells you how the tube fits in the socket is broken off. Any way to tell which way the tube or adapter is supposed to fit in the socket without experimenting and frying the tube?
- ...
- 9 posts total
ozzy, that would work if there were other tubes to check but in this set up, it's the 6SL7 that is broken, along with both my 6SN7>6F8G tube converters
that I'd like to not replace. imhififan, thanks, that's a great replacement piece. Not sure how I would know which direction to install it however. arion, yes, the pin is completely gone. |
I have the same experience, and had to resort to using magnifiers to try and determine if there was a little more of a chip where the directional 'tooth' had snapped off. Fortunately, there was just a tiny extra piece missing where the tooth protruded. Once found, it is a great idea to mark with a black dot on the tube base, just where this tooth pointed. |
| Post removed |
Not sure how I would know which direction to install it however.If you have a DMM, you can identify the filament pins by using continuity test. In the case of 6SL7, the filament pins are 7 and 8. http://www.tube-fullmusic.com/Fullmusic%20Tube/6SL7/6SL7_01.jpg https://lh3.googleusercontent.com/proxy/zkwJL9ulSQRrAamWEPO2Ows4F-Fy7fMd-iu_9Pu09fbrsjlkCcnBAPfgijm7... |
- 9 posts total