I hear ya. Though if I personally spoke to someone directly at Pass and they stated specifically for the xa25 it holds no merit. Maybe they are onto something. The ear is quite subjective. Additionally I’m looking at two weeks for break in.
Recommendations for power amp placement/dampening
Hi all,
I will be receiving a moderately hefty solid state power amp (50 pounds) within the next two weeks.
I have a mid century modern two tier table where the pre and dac are placed. I was considering getting a 3” butcher block with steel spikes. Perhaps there is an alternative isolation dampening technique that might be more ideal.
My floor is carpeted and plan to place the power amp underneath the table onto the floor. Thus creating a nice tidy set up. There would be more than enough room for dissipation of heat.
Would this be an ideal setup? Or would anyone care to suggest a viable alternative without going into the hundreds.
The butcher block is about 150 with shipping. Steel spikes about 25.00. I’d like to stay below 300.00. The main goal is to deflect low frequency vibrations.
Thanks!
Jacob
I will be receiving a moderately hefty solid state power amp (50 pounds) within the next two weeks.
I have a mid century modern two tier table where the pre and dac are placed. I was considering getting a 3” butcher block with steel spikes. Perhaps there is an alternative isolation dampening technique that might be more ideal.
My floor is carpeted and plan to place the power amp underneath the table onto the floor. Thus creating a nice tidy set up. There would be more than enough room for dissipation of heat.
Would this be an ideal setup? Or would anyone care to suggest a viable alternative without going into the hundreds.
The butcher block is about 150 with shipping. Steel spikes about 25.00. I’d like to stay below 300.00. The main goal is to deflect low frequency vibrations.
Thanks!
Jacob
- ...
- 16 posts total
- 16 posts total