2. cables
  3. 158690-118990

How to select a good Speaker Cable

Speaker cables do have a significant role in how our system sounds. Different cables sound different. 

So which one is the right one for you?

The Speaker Cable is an extension of the Amp. and not an addition to the speaker's load. It shall have a certain resistance (low) not to spoil the Amp's DF figure. As so, it can be calculated and there is a formula to do it.

The higher the Amp's DF, the lower the Speaker Cable's resistance shall be. As today SS power Amp's get DFs of 400 and above (Digital Amps go by thousands) the cable of 10 ft (3m) long, gets as thick as 0 AWG.

I can see your eyebrows elevates, when that thick cable is to be deal with. Most Speaker Cable makers skip it because of that. So most cables on the market (regardless of the look or price) are of 14-12 AWG. Way less that supposed to be.

Worst! no Speaker Cable maker, dealer or seller knows the answer, of what is the correct cable for your system. 

So most of us ended up, with a cables too thin for the task.

A conducted test, on this site, about a year ago as well as with some closer friends, shows a significant improvement with a calculated size cable over their previous cable. The results were all positive and preferred the calculated cable.

So, instead of asking: which of two brands, or two prices or two colors of Speaker Cable do I need, you should ask how thick of a Speaker Cable do I need.

I'll be happy to provide you the calculation, for who request it. All you need to provide is:

1). Length (Ft. or meter)

2). The Amp's DF figure.

Thanks


128x128b4icu
b4icu's avatar
b4icu OP
558 posts
 
Mr.  djones51
It's getting a bit annoying...
If you are not going to bather with my idea, why do you keep nudging on endless errores issues?

Most Amp's on the market will not deal with a load as low as 1 ohm and will shut down. For most 8 ohms rated speakers, the impedance is between 3 ohms and 30 ohms.
Running 50' of speaker cable is not recommended.
Buy a long XLR cable and place the Amp. as close as possible to the speaker.
Most speaker cables out in the market, used by sound owner is about 10ft, give and take 2ft.
The best would be to use two monoblocks as close as possible to the speakers (even put them back to back and use very short jumpers. The distance between the power Amp's and the Pre. can use XLR balanced cables of extended length if required.
It is essential to lower the cable resistance and one good way doing so is shorten it. The other is getting it thick.
It's your choice which suits you.





sgreg1
612 posts
 
If you think Richard Vandersteen knows anything about speakers he always says use the shortest speaker cable possible and longer component cables for the best sound. Not the other way around. When running all your calculations don’t disregard length, it can be more important that gauge.
b4icu's avatar
b4icu OP
558 posts
 
Mr. sgreg1

Thanks. I do take length into my calculation. Length and DF.
The outcome is the thickness (# awg).
The thing is, that the Amp's DF and required cable length are a given.
The thickness is the outcome.

None balanced cables (interconnect cables) over 3ft. are a bad idea.
Try to avoid it.


glupson
7,842 posts
 
"Yes. But it was 2 years ago. It's time to undust it again..."
Some skeletons are better left in the closet.
volumizer
86 posts
 
LOL!

Fat copper cable.  Short run.  Excellent contacts.  Nuff said.
More to discover