Tubes?


I have Revel Salon 2 speakers. Sensitivity is about 85 db. and 4 ohms. They are power hungry speakers. Currently, I am driving them with McIntosh 601's and a McIntosh solid state preamp. I was look looking at a pair of McIntosh MC2301. They are tube amps rated at 300 watts into 2 - 8 ohm loads. I listen to all types of music (sometimes at very high levels). I never run out of power with the 601's, but I am very intrigued with tubes. This may be a misconception, but I remember some friends who played guitar saying, tube watts were louder than solid state? Perhaps this is not really true or not true regarding home stereo. Perhaps the best idea is to keep the 601's and get a good tube preamp?                          Thanks, Dave 
128x128tobor007
And it does crack me up when phase accuracy of the amplifier gets mentioned with speakers that start out the impulse test 180 out or with midrange wired out of phase...

it’s a system people :-) 
- sure you can get higher output but at what cost ?
$33,000? The first breakup in my system occurs at 35Khz. The speakers are 98dB and 16 ohms, go flat to 20Hz. Classic Audio Loudspeakers Project T-3.3
@tomic601 

much wisdom in your posts about transformers and lost detail earlier in the chain

we shd all remember that when we obsess over gear
Ralph at what cost was a reference to trading one sonic virtue for another. I am elated you have found a truely pistonic set of drivers from 20-33k. Another lap around the Mulberry....at least it is with somebody i deeply respect

perhaps it’s definitional, but i think of breakup as signal going one way, cone or parts of cone going the other way...$600 bucks and a run across the German laser scanner is a truth machine...

best

Jim
I am elated you have found a truely pistonic set of drivers from 20-33k. Another lap around the Mulberry....at least it is with somebody i deeply respect

perhaps it’s definitional, but i think of breakup as signal going one way, cone or parts of cone going the other way...$600 bucks and a run across the German laser scanner is a truth machine...
@tomic601

We’re on the same page with this... and I knew what you were saying when you asked ’at what cost’ but since the speaker I referred to does not seem to have a downside other than size, it actually came down to its actual cost, so my comment was a bit of a double-entendre :)