Isolation Devices, Something to put on top of unit


Hello, I need to find a good device(s) /or/ method to kill the airborne vibrations that attack the top of my cd player and preamp... Basically the shelfs under the components are completly dead, you can not feel anthing coming thru the rack or the bottom of the units, its just the top plate of the unit, which is the largest and weakest surface area anyway... but again the rack is excellent, it has 3" thick maple shelfs and with full bass in the room does not show a hint of vibration. Don't get me wrong the system sounds excellent and never skips or does anything funny because of the top plates dancing to the music, but of course I would like to eliminate this.
-Should I just get some 2" solid maple blocks that fit on each unit and do it this way as this is how the shelfs are, with like a sheet of fabric inbetween or something?
-I would like to keep this situation as CHEAP as possible, again I would like the benifits but really the system performs flawlessly.

--I have a turntable in the system too, it never skiped once at full output so its good, the plater does not vibrate, just the dustcover(so I just leave it open

--Wadia CD player never has a problem but would like to put something on top. It does not get hot.

--Mcintosh Pre-amp like to put something on top, it does not get hot.

Thanks fellow audio people
matrix
Sounds good guys, I'll take a look, yeah you can only do so much I know that, just want to do something rather than nothing you know what I mean? Thanks
I have a couple marble tiles, that I put back to back weight around 10 lbs, they seem to do something decent, I have some isolation pucks that I set them on, but can still feel the top vibrate a little, so should I dump the pucks and go with a fabric or something to just lay them flush on the top of the player? thanks
When properly grounded mechanically you want to provide only one surface for vibration to exit. By having something on top you are disrupting the energy flow at the bottom of the chassis which can be grounded more easily and effectively. If you are concerned with quieting the chassis yet still want to couple properly try using all brass hardware to mount the lid, circuit boards,transformers etc. within the component itself. The brass has superior sound quality does not ring like the typical steel hardware used and is non ferrous so it is less disruptive to signal flow within a component or speaker.Tom
very interesting, problem is the Wadia is like a damn lockbox, can't get it open without some special tools, it uses a very off size like 2.5 mm Torx bit, which yes I can remove a few, but can't get the rest as it has some type of internal latches... also it does not have "Top" plate it is all one box that slides off the unit in one piece, so it is not seperate where you can just take of the plate, virtually they entire unit would need to come apart... I am not sure but I believe they did this to Deter anyone from trying to easily copy the digimaster system housed inside.