Crimping Furutech FP203R spades

I haven't done the hydraulic press thing (I didn't look for a tool).  I do know these FP-203 spades are impossible to crimp with normal tools.  I have always used the FP-201 spades instead.  They have screw-down clamps to hold the speaker wire, and you can still apply solder through a hole at the top.  Just make sure you use a larger 2mm tip and crank the heat up to max (like 450 degree C).  Be patient because it takes a little bit for the spade to heat up (it's a giant heat sink).

Thanks for all the input,
I'm going to look into Total Contact, also.

I have all Furutech outlets and S032. I soldered all the spade connectors.

Anyone has still more tips on this? Specifically from shops in EU?

Same answer as in June of 2020. It looks like the link from then expired but this is the same tool I linked previously and still use, and it is not too expensive. Amazon has quite a few different models here. Still using with those crimped FP203 spades, for probably around 10 years now, and and they still holding up just fine.  However, I wouldn't argue with soldering them.