Vertical tracking force for Lyra etna lambda sl catridge

Dear @newtoncr : That you are wrong with that set up and that just forgeret about those " professionals " you mentioned and put in touch directly with the only gentleman that can help you: J.Carr Lyra designer.

Btw, @geof3 the OP cartridge and the V is spot on: 10hz in the combination frequency resonance.

newtoncr, again put in touch with JC. Btw, a cartridge like the one you own needs around 60-70 hours of playing to settle down and after that playing time hours you need to make the true fine tunning and this means to make a in deep and very carefully overall cartridge/tonearm/TT/phono stage set up according the cartridge needs always inside the Lyra alignment/set up specs.

R.

@newtoncr the first steps for any cartridge set up is to own a small round level and first check at the TT platter center ( nearest to the spindle. ) that must be dead centered in the level, then make the same at the TT arm board, next in the tonearm base and after finished the cartridge overall alignment/set up check with the level that at the tonearm pivot/fulcrum the left/rigth sides in the level are dead centered ( if the AZ alignment is independent of the pivot. ).

R.

JPerry,  I did figure that you misspoke.  But "slanted from back to front" is more precise, although still not precise.  Anyway, thank you for the clarification.

@newtoncr : Other two importants subjects with the V tonearm is that is a balanced design and you must/should be use it in static mode the other issue is that the tonearm is well damped design: magnesium is good self dampened material and the tonearm is tapered that between other things avoid standing waves but additional to those characteristics SME designed a silicon tray to improve the cartridge/tonearm damping in favor of quality level performance in what we are listening.
Some owners do not like to use the V tray and orthers ( as me ) do it, this is up to you.

R.

Hi there @newtoncr I’m a bit late to this post, but having recently acquired an Etna Lambda SL (which is fitted to a Linn Ekos SE tonearm), I have found that the cartridge sounds best at 1.75g – a little heavier than the recommended ideal 1.72g.

The instructions that came with the cartridge state:

‘Note that Etna SL (Lambda) features a new high-performance asymmetrical damping system, designed to make the signal coils precisely parallel to the front and rear magnets during play. The angle between signal coils and magnets is affected by tracking force, and we strongly advise not to deviate beyond our 1.68-1.78g guidelines. Setting tracking force so that the cantilever is exactly perpendicular to the (yellow) front magnet carrier during play should result in the largest dynamic range and best sound.’

I don’t know whether/how much the suspension will soften with break-in, but at 1.75g the cantilever is still not quite perpendicular to the front magnet during play (I estimate more like 95 degrees), which indicates scope for further increasing VTF.