Subwoofer for Wilson Maxx2

same case...it was driven by my FM acoustic 244A + 611 combo, speaker cable was FM forceline 5 ,and I/C was FM PIT

i started from 2 ft from the rear wall, however the funny things are..the mid and high Charity really so much better at the range of 10.5ft to 11ft at my room, really so much more enrichment than 4 ft..6ft..5 ft..8 ft.., but just at that range

now the speaker is about 2.4 meter aparted,

i am looking into some DIY infromation for a bass trap, i did made some but not properly measured etc..

wonder...JL Labs F113 , which are 13 inches driver..would that be a bit too small ? ANy comment for the JL 212?

I am seeking a pair of watch dog I ( which is active, and cheaper)

>>> Stay away from Velodyne not up to the task, slow and does not have the mega output of the JL.s <<< ... thx for sharing

REL sub ..seem capable..

well understood, trying to blend othr brand subwoofer with th maxx2 is a hard task

although i do not to pay too much for for a pair of Grand Slamm SIII if i sell my Maxx2, however i suspect, thing will be more or less the same, and i demand a pair of subwoofer

toe in until i sort of see n not seeing the inner side wall and adjusted the head angle based on the manual and fine tuned within 2 ladder steps

Oracle (appropriate!)...

I appreciate your vast experience but do not believe 11ft into a room is likely appropriate placement. I also do not believe it makes solid sense to crossover Maxx 2 at 60Hz. And....I also believe it difficult to integrate most subs with Wilson speakers and from my experience, which included the JL, Thiel seamed closest. And...I also believe it very important to adjust the head unit, toe in and spikes if you move Maxx's.

"Totally wrong..." is likely a little strong.

To the OP...Re cables, MIT has always worked for me. Pricey but I have not found a better match in my system.