Problem with phono stage

Chakster, I guess the "operating principle" of the MP cartridges is not being used to "decrease inductance", per JCarr's summation, because the MP110 has very high inductance according to any info I can find on the internet.  The operating principle seems to be used to increase output, because the output of the MP110 is MM-like, even if it's not an MM cartridge.  So we have an IM cartridge that measures like an MM, both in voltage output and (high) inductance.
Raul, if the MP110 has inductance of ~800mH, as per VE discussion groups, then its resonance can fall well below 20kHz, if capacitance and R are not adjusted to prevent that.  And Mijostyn, if the foregoing is true, then it does help the OP to understand why ticks and pops may seem prominent, and it gives him some idea what to do about it.
To paraphrase Albert Einstein, it's good to keep things simple, but not so simple that a valid hypothesis is ignored.

A quick look at online pictures shows opamps in use in the Black Cube.  Now there are different black cubes so I may not be looking at the right one.

I used mine with Sound Smith Moving Iron and other MM carts.  I had no issues.

As to feedback it can be employed with opamps as well as transistors.  Opamps are easier to set the gain and have good common mode rejection ratios.  Transistors have to be matched.  So in lower costs products, opamps are more likely to be used.

Looking at pics of the Arcam R phono it is also using opamps.

For those that don't know how to spot a opamp look for a black square with 8 legs near the input jacks.  The part number also tends to start with OP.

A slower opamp will also be less noisier, smoother and a bit less detail.

Gain depends on the number of stages but typically expect a gain of 40 to 60 on the first stage.  That gets the signal out of the mud and allows the common mode rejection to come into play to reject noise.

IV phonos also typically use a opamps.  A resistor in series to the signal sets the current which is then gained up by the opamp. 

You can find lots of literature from Texas Instruments.

As to the debate of whether opamps, transistors, or tubes are better that is a a different subject.  There are good and bad examples of each method.

I still would address the record cleaning issue.

That is it for me.  I will leave the navel gazing to others.

Well this escalated quickly, from the last few posts I think of use for the OP Mijostyn summarized

Phono stage overload, loading and lower capacitance cables have been mentioned. Does anyone have other ideas for emilm to try?

I would add if the cable in addition to low capacitance can have some shielding (always low capacitance listed by the manufacture of the cable with the shielding included) if you go DIY shielding results could be unpredictable.

@mijostyn : ""  ego discussing issues that have very little relevance to 90% of us...."""

not was you in your very first post in the thread who asked for and even shouited by your " friend " from you are a follower?

What are you claiming for?

R.

@lewm  : You can't stop your self in the same " boring " subject:

""  MP110 has inductance of ~800mH, as per VE discussion groups.."""

I told you your sources are wrong, I stated that cartridge inductance and is lower than half your figure. Please stop to post the same or at least don't name me any more in this thread in that capacitance issue.

R.