I think a lot of this has to do with just being concerned about good speaker wires. Someone who is going to bi-wire their speakers is spending extra. Usually bi-wire should be and is lower gauge or thicker before they terminate. This heavier wire should provide better sound. The jumpers provided by the speaker company can be fairly thin. Not good. The jumpers don't provide the continuity that you would want if you purchased expensive speaker wires. Spend a grand on speaker wires that end up going through a ten buck jumper?
High end speakers without bi-wiring?
Recently, I've read quite a few posts that disclaim the benefit of bi-wiring. The claim is that for bi-wire capable speakers, there is no noticeable difference between bi-wired and single-wired connection, assuming good quality jumper cabbles are used for single-wired configuration.
Then, is there a move from high end speaker manufacturers to forget about the bi-wiring option and just provide single wire for their high-end speakers?
(Well, bi-amping is another issue, but let's not consider bi-amping.)
Then, is there a move from high end speaker manufacturers to forget about the bi-wiring option and just provide single wire for their high-end speakers?
(Well, bi-amping is another issue, but let's not consider bi-amping.)
- ...
- 27 posts total
- 27 posts total