New Mcintosh, broken out of the box. VERY rare.
Regards
Regards
defective pre-amp
Bought a new C47 McIntosh and hooked it up to my Sony UPD800X DVD player.
I have a new set of headphones that are 103db sensitivity. I used a new Pangea Coax cable.
When listening thru the headphone Jack I get lower volume than normal and lots of hiss. I tried 2 DVD player and same thing. Any ideas? bad headphone amp inside or bad DAC? I am next going to try a different cable....
I have a new set of headphones that are 103db sensitivity. I used a new Pangea Coax cable.
When listening thru the headphone Jack I get lower volume than normal and lots of hiss. I tried 2 DVD player and same thing. Any ideas? bad headphone amp inside or bad DAC? I am next going to try a different cable....
- ...
- 8 posts total
I take it you looked at this, sounds like your still muted, with hiss and low output level. The C47 Default Setting for using Headphones is to automatically mute all the Output Connectors when the Headphone Cable Plug is inserted into the C47 Front Panel HEADPHONES Jack. There are three available settings: Mute All Outputs Mute Main Output Mute No Outputs 6. Rotate the INPUT Control until “SETUP: HEADPHONES, Mute All Outputs ” appears on the Information Display. Refer to figure 26. 7. Rotate the VOLUME (ADJUST) Control to change the current HEADPHONES setting from “Mute All Outputs” to either “Mute Main Output” or “Mute No Outputs”. Refer to figures 27 and 28.Cheers George |
- 8 posts total