SUT into MM input section of Solid State Phono Stage

Yes, I know that my Forte is not a State of the Art phono stage.  I had bought it to be used just as a backup for my main phono stage.  I never thought of the Forte as being bad, but I was certainly cognizant that there are much better available.

However, when I hooked up my Tango SUT to the moving magnet section, I was simply amazed at how much nicer this combo sounded than simply using the MC section on it's own.  What an incredible difference!  It still doesn't compete with my Tango/Artemis Labs Ph-1 tubed phono combo, but man... I have to say I was shocked.

So this experiment just made me wonder if anyone here has tried it themselves (using your SUT into a solid state phono).... you might be surprised at what you hear.

I think most people probably use their SUT into the moving magnet section of their tubed phono I as do.  Anyhow, was just wondering.

Best Wishes,
Don

@no_regrets Yes , i have used a Entre ET100 SUT wiith a Roksan Reference phono which is solid state op amp based and i prefer it better than through the MC setting in this phono stage.

Not sure why do you think most people use tube phono stages? I think you are wrong. I’ve been using SUT only with Solid State phono stages. I must say that current-injection phono stages are much more impressive than SUTs and MM phono.

What must be matched between a SUT and the cartridge is the SUT gain to the cartridge output level, this is the main issue and not impedance loading.Any SUT with the rigth gain can works with any cartridge with the adequated output level it does not matters its impedances.

This is at best misleading.  I agree 100% that the sole purpose of the turns ratio is level matching.   It is best to match a SUT for both step up ratio and cartridge impedance.  Taking the two extremes of a 2Ω and a 40Ω, a 2Ω cartridge feeding a SUT designed for 40Ω will have bass response down to the single digits and show a pronounced resonant peak at some point (hopefully) above the audio range.  Going the other direction and using a SUT intended for a 2Ω source with a 40Ω cartridge will result in inadequate low and  (possibly) high frequency response.

dave

D@intactaudio : That’s how the SUT react not the cartridge. I think that you can do what you posted ( dedicated SUT. ) because you make your own SUT. I’m talking of normal SUT and I own quite a few that I tested in a very high resolution system and what you posted I just can’t detected.
Your post appreciated.

R.