Flush wall plug for power cables?

Thanks for all the great recommendations:
I took off my outlet plate and the outlet. I cannot remove the current outlet box to install the recessed box so there is not enough room unless I want to perform a lot of sheetrock work.
I think what I’ll do is buy some flush angled connectors and replace the current ones with these on my cables. Sounds easy enough, but I’ve said that before.
Maybe if I call some cable company’s, like Voodoo, they will custom make me a cable with the flush plug.

If you want to do your own ends for tight clearance.

http://www.furutech.com/2015/07/21/11446/

Perfect. Thank you. I’ve never done it but I’ll give it a go.

jb505,  it is not too difficult a task if the current cord has a non-molded plug end.  The plug will disassemble fairly easy leaving the hot, neutral and ground wires pre-stripped and ready to go back into the new plug.  If it’s a molded plug then you have a bit more prep work to do after cutting off the end, but still not high on the diy difficulty scale.  Several good YouTube videos to watch to get you acclimated to the job.  It looks like you are in the Sacramento area?  I’m sure someone from here that is close by and proficient would offer to assist should you want to go that route.  Heck, if you were near Philly I would gladly do it for free.
Wishing you success on your project

Thank you bry. Actually my friend, unbeknownst to me has made his own cables and offered to help me out. So we’ll tackle this next weekend. He says it shouldn’t take long.However, I did buy one of the adapters from Voodoo recommended by two left ears.