2. amps-preamps
  3. 163407-139109

Red Plating??

I have a CLASS A KT88 amp that has an autobias circuit.  The company rep recommended SED 6550C Winged C tubes.  I purchased a quad of them.  They bias OK and they sound wonderful but I just noticed that they red plate a bit. If I can figure out how to do it I will attach a picture.

The red plating is just in the inner corner of one of the plates on all 4 tubes.  It looks as though I am looking at the filament through a translucent plate but I know that its red plating. 

https://imgur.com/a/RVLWPcf

Can I operate like this safely?  The bias does hold steady and does not fluctuate. The red plating does not change.  As a Class A amp this status should hold steady.  Of course, it does run hot. If all that it hurts is tube life, thats OK.  These are my best sounding tubes without a doubt.

chinook9
atmasphere's avatar
atmasphere
12,097 posts
 
That is 5VA, not 5A. This is a low voltage transformer for things like doorbells.

https://www.ebay.com/itm/Edwards-590-Transformer-10V-5A-Load-120V-Line/121034476341?hash=item1c2e378...


Ebay has premade bucking transformers: https://www.ebay.ca/itm/Bucking-Transformer-Voltage-Reducer-For-Fender-Marshall-Gibson-Vox-Ampeg-Etc...

Good catch! - thanks.


I was not aware of the product for guitar amps but its nice to know about! That would be perfect for this sort of thing, if line voltage is all there is to it.
yogiboy's avatar
yogiboy
5,820 posts
 
@atmasphere
It looks like the 6550 is back in production. This place has them listed as new!
https://tubedepot.com/t/tubes/power-tubes/6550-kt88-kt90
atmasphere's avatar
atmasphere
12,097 posts
 
Yes, there are now several varieties. Electric guitar players like them for the distortion they make.
eagleeye7
23 posts
 
You could use a "Constant Voltage Transformer" (Good small one about $200) which would even out Voltage Spikes & Noise, assuming it supplied sufficient current for your AMP..

I utilize a single CVT for all but my Main Power Amps (which are plugged directly into a dedicated 20 amp line), the CVT provides the best results for Sound Quality from smaller current draw complnents
ieales's avatar
ieales
1,201 posts
 
A CV or Isolation Transform is a 1:1 device. It does not reduce the input voltage unless running above rated current. For proper operation, the load must match the device capacity.

It provides isolation and reduces some noise components, some by a lot.


More to discover