Speaker cable length


Hey y'all,

I'm thinking about changing the setup of my rig so the equipment rack is off to the side and nothing is between the speakers. However, that's going to entail a much longer set of speaker cables. Is there anything about speaker cable length I should be aware of? And and am I right in assuming that I need to keep both pairs of cables equal length?
simao
I just swapped out my Benchmark speaker cable with SpeakOn termination for some Audience FrontRow also with SpeakON terminations (you can get any termination). I only need 1 meter lengths because I have monoblocks right beside each speaker. I use 15 or 25 foot of Benchmark XLR cables to connect my amps to my preamp. This way my rack is sitting beside me and nothing is in-between my speakers.

Comparing my FrontRow and Benchmark cables are an apples-2-apples comparison. One cost $200 and the other cost $3600.  The Audience is a bit better but I was very happy with the Benchmark prior to the FrontRow. I only bought the FrontRow because I had saved so much on my other gear that I had some extra cash in the stereo budget to splurge.

If you are going to use very long speaker cables I suggest you use some pro cables like the Benchmark so that you do not get killed by the cost. They are excellent.
Post removed 
I've heard and seen a lot of systems with equipment between the speakers. It shouldn't be stacked "between" the speakers. If you go low and against the front wall, there is nothing wrong with that.. HECK just low and streamline works perfect for me..

As far as between speakers one of the best setups I EVER heard was a 3 speaker Trainural analog system. It had a 3rd speaker dead center, and recommends an equal or BETTER speaker for the center..In other words BIGGER.

Like MC said the give away compared to gain, you've lost ground..
Move part of it to the side. Pre, TT and amps leave them by and between speakers, just LOW...

My monitors the lowest driver "used" is 18" off the ground. That make a BIG difference too. What exactly is being messed with when drivers are that high? Something above 18"? Use the 18" and below. No problems for me.. Folks have better ears than mine, for me it's maybe a change, but not an improvement in SQ.. There is always a work around.. Just fruit for thought..

Regards
I moved my vertical rack to the side wall. I was using Purist Audio cables and changed to Canare 4S11. Both cables are 15ft. At this length nobody will hear the difference between same length and one long, one short.
I like them more than the $2500 Purist, and there's no noise or RFI being introduced.