Inexpensive all in one options


Hello to all. it's been a while for me.

just had a major meltdown with my 10 year old setup and find myself feeling like Rip Van Winkle scrambling to find a new digital front end for a temporary system.  understanding a decade in digi can be like dog years, was hoping for help finding a decent streamer/dac with preamp capabilities?.

back story....right before Christmas, my amp went south and took the speakers with (ML436/Aerial 7B's).  I'm a part time hobbyist who generally puts together a decent system and enjoys for many years. until something compels me to upgrade/do it again, i just sit back and enjoy what i have. dead amp and speakers are very compelling. don't have the time to rebuild properly right now. all the research/auditions/time required are not doable now or anytime soon. need something to get by for a while...1-1.5 years ish.  Not having decent music available was/is not an option. amp and speakers were relatively easy. spent a couple hours researching then picked up a new amp and some pre-owned speakers here on agon.  ended up sounding pretty good and thought i was done. this gear will end up in my living room down the road after putting together the real listening room setup.

2nd week with the new gear, my PS Audio Perfect Wave Transport fails. fixed cost repair/refurb is roughly $800, so it's an easy no in my mind. off to the trash bin with the PWT. as much as i enjoyed it, actual usage was down to 10% max with streaming being the remaining 90%. Hi Rez is probably 75% of my streaming.  My Perfect Wave Dac mkII was still working fine and could keep me going/happy for a while.  done/all set again i thought. THEN!!....the PWD started acting up last night !!. so when it rains it pours. my entire 5 piece system has circled the drain in about 5 weeks. was left with a bunch of nice power cords, interconnects and speaker cables. that's it.

bottom line now/point of this long winded post is i need a quick replacement for my PWD. had used it has a pre-amp w/volume control into the ML/Aerial system (RIP) for many years and loved the sound of not having a stand alone preamp. would like to avoid needing to get a preamp now as well

What I need...bare minimum
Decent/good DAC
Streamer from my PC (wifi and ethernet cable)
Internet radio along with common/popular streaming services
Balanced/XLR outputs
Pre-amp w/volume control
Hi Rez capable (obviously)

Trigger for amp turn on would be a nice plus

would like to spend south of $2k and prefer new or something somewhat new-ish/only a couple years old tops. could go a little higher then $2k if "compelled" to do so. the only two options i've looked into are Cambridge Audio products.  The CXN V2 and 850N. both seem like they'd work fine and check all my boxes. Looking for other options my limited/one evening of research might have missed..... or a recommendation on either of the Cambridge products above. want to buy something asap so please chime in early and often.

**as a side ask.....have been using J River for 10 years (old version JR 18 lol!)). am guessing that will need to change depending on what i end up with?. any suggestions regarding  streaming software would be great.

thx in advance

cheers
Rip Van Winkle
Levy


levy03
What about the new KEF LS50 Wireless IIs for $2.5K? Just need Ethernet to enjoy Roon, but has input for disc player and output for subs should you want to extend. Or for an additional $10K the Dutch & Dutch 8C might be attractive, and no need for subs.  With the miniaturization of electronics, active speakers may be the wave of the future. 
Well OP, unless you're in sand land.. I'm close, sand dunes all around along with pete and adobe dust in the summer..
The sand is a real killer for somethings though.
Caddy drawers take a beating, that kind of stuff..  
Environmental issues? Dust, moisture, rough handling, lack of maintenance.

 OR

 An outside intermittent electrical issue, even static discharge issues...

I'd get the utility to run a tape at no cost. See if the voltage is LOW, that is my concern. Not high.. worse both low and high.. yo yo (ing) voltage, wonderful to deal with..
 
If you have checked everything.. I'm still wondering..

Looking at a 60 year old MX110z that just sounds wonderful.. I've gone through about 4 sets of valves in 20 years..
The same number of fuses. I have a few OLD pieces, never touched..
65 years old.. Again just new fuses.. and valves as needed. 

Happy hunting ....

Regards

https://www.nordacoustics.co.uk/

<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>


Look at Nord, I have several of his amps, NEVER a problem, great customer service. Good prices..

DACs, Integrated, streamers, all kinds of options..

I use his NC500 with rev D buffer boards and Sparco 2590s. Brilliant, is all I can say. Good looking pieces too.

Regards
no worries Hvymec...had an electrician come by (also a neighbor). he spent a while checking everything inside and outside. 30 year pro so i'm all good. will take a look at Nord and WSRRS's peach tree suggestion

Fuzztone: think we established early on there are many things you know/can do that i can't/probably shouldn't even try LOL.  will definitely need plug n play and should have mentioned that early on.  never heard of Soekris but the 2451 sounds like a great dac. hard to find is another deal breaker. am extremely busy and pushing off the real rebuild for another 1-1.5 years. something that's inexpensive, easy to get/setup/use and sounds decent....maybe even good if possible??. 

the two Cambridge's on the list (cxn v2 and 851n) is very close. my main concern is sound quality with cambridge.  coming from what i considered a good front end (PWDII/PWT), will the cambridge options at $1000-$1500 sound decent/anywhere near as good?.  or has 10 years in digital development made current mid-fi as good/close to older hifi? 

kinda leaning towards just grabbing a cxnv2 and giving it a try.  just don't have time for all this thinking and want/need music NOW. can always return it if it lets me down. maybe it'll surprise me?. have never listened to cambridge gear. 

thx to all for input.