Why would it not be just a matter of slinging a higher grade cap into the crossover. if the values are the same, shouldnt they electrically do the same thing and then its just a matter of the better cap doing the same thing better?
upgrading speaker crossovers
I have a pair of PSB Stratus Gold'is and I am thinking of upgrading the crossovers, I am going to try this before I think about buying new speakers., which are in the area of $10000. The crossover in a speaker consists of 1-2.5mf 440vac film and 1- 6mf 440vac film by RC. then I have 4 100mf 100vac electrolytics. Why are the elecrolytics there, is this because of cost? I would much rather put in polys in their place, which will cost me $30.00 each. So my question is are the elecrolytics there because of cost issues if so can I change them to ploys?
My equipment consists of conrad johnson PV14l tubed preamp and a conrad johnson MF2500 amp. Both are right now at cj to be upgraded, the preamp is also getting teflon caps. I also have a pair of Mirage M1;s that I have upgraded with SI tweeters and Woofers. Must have gotten the last ones from them because now they will not even talk to you about the speaker when you call.
Anyway any advise on upgrading the crossovers would be greatly appreciated.
My equipment consists of conrad johnson PV14l tubed preamp and a conrad johnson MF2500 amp. Both are right now at cj to be upgraded, the preamp is also getting teflon caps. I also have a pair of Mirage M1;s that I have upgraded with SI tweeters and Woofers. Must have gotten the last ones from them because now they will not even talk to you about the speaker when you call.
Anyway any advise on upgrading the crossovers would be greatly appreciated.
- ...
- 29 posts total
- 29 posts total