@clio09 I wasn't really saying you were wrong, nor did I feel that you were saying that I was either, but I felt from your comments that I should flesh some things out a bit more. I agree with everything Roger states from your comment above. Despite conversations like this nothing is going to change; although people reading this might be a tad more careful.
Older solid state amps tend to run too little feedback which is why they can sound bright and harsh. Driving higher impedances helps with this simply by reducing distortion, which is the source of the brightness.
I think Roger didn't like that we run no feedback in our OTLs but the reason was I knew that if we used feedback, the phase margins of the amps would never permit enough to be applied. That's actually true of every tube amp. So to prevent the dreaded brightness coloration we ran no feedback at all and relied on other means to keep distortion at bay.
Older solid state amps tend to run too little feedback which is why they can sound bright and harsh. Driving higher impedances helps with this simply by reducing distortion, which is the source of the brightness.
I think Roger didn't like that we run no feedback in our OTLs but the reason was I knew that if we used feedback, the phase margins of the amps would never permit enough to be applied. That's actually true of every tube amp. So to prevent the dreaded brightness coloration we ran no feedback at all and relied on other means to keep distortion at bay.