Arrows on cables.


I can never remember but what direction should the arrows on speaker and interconnect cables be going 
cortw1965
hmm, I guess I connected my speaker wire properly, they at tellerium Q, so the arrow goes from integrated amp to the speakers.
No one has addressed tape loops and the inconsistent labeling that can accompany the inputs and outputs ;-).
If you look at the wire it lays like shingles on a roof, 1000 x will do it.

If you keep the orientation just like caps and inductors it does make a difference.  Not only in sound but the QC between cables..

A bidirectional barrel Capacitor is still rolled up from small to large, the wire is on either end of the wrap. IT makes a difference which way you solder them in. The same applies to cable construction.

If a manufacture CHOOSES to care for either or neither makes a difference to me.. I KNOW it change the sound consistencies between cables, not create anomalies.

If one manufacture told me, "the draw through the dye didn't matter and one did", who would you pick? 

THINK before you answer... Who is really being PICKY about the construction and paying attention to it...  Charging you thousands of dollars and CLAIM to be expert cable builders.. NO YOUR SUCKERS.. 

EASY = I just don't care enough to LOOK at a cable and then assemble it. Or did I mix up LAZY with EASY.

Do you walk away from a fool and his money?

Regards
if you connect the cables the wrong way, you need to sit behind the speakers and then all will be right

two wrongs don't make a right but in high end audio the golden rule is broken