Just seeing this, what else is there to do but coil the excess....unless you fold it over back toward speaker and then back towards amp. I’m sure someone will find fault with that too...not much you can do when most recommend the same length of cable per speaker. I coiled mine and I have two cables per speaker, bi wired. I doubt that anyone would here a difference if I uncoiled them.
Coiling excess Speaker cable, is this a problem?
Hello!
I have a question that maybe you could help me with. I have been told that you should keep the lengths of speaker wire the same to each speaker. As a result, I have 2 (BiWired) cables going to each speaker, due to my system set-up, I have about 8' of two cables neatly coiled up next to my system rack. Though I am not detecting any sound reproduction artifacts, are there any potential deleterious problems I may not be aware of? I did take a photograph of this but I could not figure out how to paste it here.
Thanks for your help!
I have a question that maybe you could help me with. I have been told that you should keep the lengths of speaker wire the same to each speaker. As a result, I have 2 (BiWired) cables going to each speaker, due to my system set-up, I have about 8' of two cables neatly coiled up next to my system rack. Though I am not detecting any sound reproduction artifacts, are there any potential deleterious problems I may not be aware of? I did take a photograph of this but I could not figure out how to paste it here.
Thanks for your help!
- ...
- 19 posts total
| Post removed |
- 19 posts total