2. amps-preamps
  3. 167082-153886

Why do people say low power amps should be good for bookshelf speakers?

I was in a BB Magnolia recently and they had a McIntosh MHA150 integrated headphone amp that can also do 50 watts per channel to speakers. The sales rep said it "should be good for small bookshelves but its not enough power for towers". 
I've never understood this line of reasoning.  Towers are typically more sensitive than bookshelves. Is there an actual reason a small amp like this couldn't do just fine for towers that are equally or more sensitive than similar bookshelves?
roberthz
earlflynn's avatar
earlflynn
461 posts
 
3. Some salespeople are alien agents looking to weaken our social network.
Take your pick.
Now thats funny.

aewarren
662 posts
 
+1 noromances.  I too think the salesman was making a generalized assumption that smaller bookshelf speakers would be listened to in close proximity and at lower volume levels and would thusly require less power. In some applications, but certainly not all, he would be right.
anotherbob's avatar
Ag insider logo xs@2x
anotherbob
344 posts
 
My Monitor Audio Gold 100’s are power hungry 4 ohm bookshelf speakers with 86 db sensitivity rating.
roadwhorerecords
282 posts
 
@tony1954  
 +1
  4. All of the above.
pedroeb
493 posts
 
The only reason might be to eliminate over exuberant use of volume, which could damage speakers, so there can be no come back on the retailer.

Maximum power is often quoted when THD+N reaches 1%. In my mind that's a dreadful figure.

Therefore maximum power is probably best considered at half the advertised figure. Just don't screw the volume up to full.
More to discover