@turntablemat
Hi Mat,
As I mentioned above, I own a tricked out first generation VPI Classic 1/2 table, which I upgraded many years ago with the help of Jack and/or Mike. The upgrades included installing the Classic 3 300 RPM motor and cap (prevents turn-on/off thumps). In addition, I switched out the Classic 1/2 arm and base for the Classic 3 stainless steel arm and base. So, I have a first generation Classic 2.7 (sic).
My cartridge is a Lyra Kleos. My electronics gear is all ARC.
So, ... I am not interested in dropping mega bucks into the table. But I was thinking about the 3D arm and maybe the SDS speed controller.
What are your thoughts about the upgrades just noted?
I also note that VPI is using a gimballed arm. Does it sound significantly better than the old JMW uni-pivot?
One last question. Do the following parts require replacement at some point: (1) the inverted bearing that supports the heavy aluminum platter; (2) the uni-pivot needle upon which the JMW arm rests; and (3) the metal bearing inside the JMW arm which sits on the uni-pivot needle.
As an fyi, I clean and lubricate the inverted platter bearing at least once a year and put a drop of electric motor oil on the shaft of the motor.
Your "care and feeding" advice will no doubt help other VPI TT owners.
Thanks
Bruce
Hi Mat,
As I mentioned above, I own a tricked out first generation VPI Classic 1/2 table, which I upgraded many years ago with the help of Jack and/or Mike. The upgrades included installing the Classic 3 300 RPM motor and cap (prevents turn-on/off thumps). In addition, I switched out the Classic 1/2 arm and base for the Classic 3 stainless steel arm and base. So, I have a first generation Classic 2.7 (sic).
My cartridge is a Lyra Kleos. My electronics gear is all ARC.
So, ... I am not interested in dropping mega bucks into the table. But I was thinking about the 3D arm and maybe the SDS speed controller.
What are your thoughts about the upgrades just noted?
I also note that VPI is using a gimballed arm. Does it sound significantly better than the old JMW uni-pivot?
One last question. Do the following parts require replacement at some point: (1) the inverted bearing that supports the heavy aluminum platter; (2) the uni-pivot needle upon which the JMW arm rests; and (3) the metal bearing inside the JMW arm which sits on the uni-pivot needle.
As an fyi, I clean and lubricate the inverted platter bearing at least once a year and put a drop of electric motor oil on the shaft of the motor.
Your "care and feeding" advice will no doubt help other VPI TT owners.
Thanks
Bruce