2. analog
  3. 167639-151430

Should the sound level in Triode mode be lower than in Tetrode

I've just got Manley Lab Series 100 vacuum tube monoblocks. And I am a bit confused what to expect from TRIODE / TETRODE modes. The user manual says that: 

"...When the switch is in the upper position, the amplifier is in TRIODE mode which will produce half the power of TETRODE operation."

In the same user manual under the Specifications section I find that the Output Power for: 


TETRODE: 135Watts (@1.5% THD 5 ohm load)

TRIODE: 65 Watts (@1.5% THD 5 ohm load)

I have been running a number of db level measuring tests by switching from TRIODE to TETRODE mode keeping the volume knob unchanged. But it appears that the sound volume remains exactly the same in both TRIODE and TETRODE modes. Shouldn't I expect the sound level in TRIODE mode to be half of what in TETRODE mode?  

esputnix
dover
2,299 posts
 
The mistake you make is that power does not equal gain.
It just means more headroom.

If I would connect a right channel output of a preamp to a 100 Watts monoblock and its right-channel to a 250 Watts one then the right speaker will be 2.5 times louder than the left one. 

No.

esputnix OP
19 posts
 
That's interesting. By some reason I have always believed that the power amplifier's wattage directly translates to volume gain. Please correct me if I am wrong, but according to what you say, I can connect left channel output of the preamp to a 100 watts power amp and the right channel to 250 watts one, and expect both the left and right speakers sound with the same volume just delivering a different headroom quality?
jjss49's avatar
jjss49
6,612 posts
 
yes

3 db difference, all else equal
Post removed 
imhififan's avatar
imhififan
2,221 posts
 
I can connect left channel output of the preamp to a 100 watts power amp and the right channel to 250 watts one, and expect both the left and right speakers sound with the same volume just delivering a different headroom quality?
Yes, if the gain of both amplifier are identical and the required output power of both amplifier is less than 100 watts to provide that degree of loudness (volume).

Let’s put it this way, the max. output power of an amplifier is the top speed of a car, the volume control is the cruise control of a car.
If you set the cruise control at 50mph on two cars, one car with top speed of 100mph and the other car with top speed of 200mph, both car will run at 50mph as the cruise control setting.
Now, if you set the cruise control at 130mph on both cars, the one with top speed of 100mph will run at 100mph and can’t go any faster, the one with top speed of 200mph will run at 130mph as the cruise control setting without problem.
More to discover