Thoughts on Active/Passive Speakers? Looking for pros and cons.

pragmas: signal processing at speaker level is a WHOLE different animal than at line level. Heat is the lowest issue compared to the rest of the losses and lack of phase control. Have you seen a proper passive crossover, how much copper is involved in air core inductors etc?  Should I post a picture of a good 3 way passive crossover so you can see?

It is NOT a disadvantage for seperate amp for each driver: active means its possible to provide the right power for each driver for matched dynamics acoss all the drivers. With seperate amps, a big peak in the bass does not raise distortion on the tweeter or midrange as it does with one amp. The cost of a big power supply and transformer for one big amp can be much more difficult and expensive to execute than two or three smaller amps.

Of course the manufacturer needs to do a good job with active- this is true of everything. It is true that active can be done cheap- especially using little Class D amp modules available everywhere now (95% of which sound awful).

IN the case I am very familiar with , ATC, the electronics are all analogue. ATC avoids digital for that changes too much too often and better to chose your own converters.

Whether analogue or digital designs, that has nothing to do with active vs passive.

pragmas: signal processing at speaker level is a WHOLE different animal than at line level.

Yes I agree, that's what I said.

Have you seen a proper passive crossover

Yes lots

It is NOT a disadvantage for seperate amp for each driver

As long as you don't care how much you spend on equipment

Of course the manufacturer needs to do a good job with active

Yes, I think I said that as well.

I get the feeling you didn't like what I said, just can't work out which bit.

I have built a active big 3 way speaker before. best bass ive ever had. but the sound was mechanical.
same with genelec 1037 that I had before, good sound, but not natural

Im a fan of low order crossover. first order assure one to have a good phase response between the drivers.

My limited experience so far seem to point that both can be good but i will stick to passive's.

Thoughts on Active/Passive Speakers? Looking for pros and cons.

I've done a lot of this comparing with the same speakers and to me a good quality passive xovers from >200hz sound better (natural) to me in the mids and highs than an active xover full of opamps.

Cheers George 

Pragmas
I actually misread your post. I thought you said a passive crossover works at low voltage, and the rest was in support of that. My mistake and I apologize.
Brad.