2. analog
  3. 166122-18254

Technics SL1000 MK3 (SP10 MK3) performance/value VS modern turntables?

I have a Technics SL1000 MK3 in beautiful condition and in it's lifetime has seen very little use.
I am ready to send it off for complete electronics restoration/upgrade, upgrade the speed control processor module and have the Krebs mods done.  Will cost about $2500.00 to have all this done.

I was wondering how this would compare to what is out there for modern turntables after all the work is done? 
Or, would I be better off selling it, and adding what I was going to spend for the upgrades to a new turntable?
I believe these should sell in untouched condition for at least $5K?  So that would put me in the $7.5K range for a modern table?

For tonearms, I already have:
New, unmounted Moerch DP8
Fidelity Research FR64S, in beautiful condition that I sent off to Ikeda/Japan and they re-wired (better silver wiring, I still have original wires) and completely tore it down and rebuilt/re-lubed.... it's just like a new FR64S.

I think this table would be hard to beat at the $7500.00 price point, but would appreciate others opinion.

Rick

128x128Ag insider logo xs@2xrich121
chakster's avatar
chakster
6,144 posts
 
@lewm After recap and resoldering all the joints, one bad transistor has been replaced, bad wire connection has been fixed, motor hall sensor has been replaced (donor part has been found). Platter edge has been polished, thrust adjusted (the difference was about 1.5 mm :) The minor pulsing noise from the motor (if your ear near the platter) is gone. All these solved.

The last issue was a cyclic fluctuation in motor drive JP need to troubleshoot.

It’s like a scientific lab where JP x-ray all the invisible problems.


best-groove's avatar
best-groove
844 posts
 
motor hall sensor has been replaced
this is what interests me; over time I bought motors with the soldered pcb of other turntables by taking the sensors and even after several replacements of all 3 sensors my TT 101 is still not able to work; I don't like buying used sensors that force me to also take the engine just to extract what I need and check that my TT 101 is working; now I'm stocking up too much of engines that I don't need and I'm tired, plus the pcb where the sensors for the 101's engine are housed begins to compromise too much after several replacements.
Do you know which engine and turntable model the sensor was extracted from to run your 101?
chakster's avatar
chakster
6,144 posts
 
Do you know which engine and turntable model the sensor was extracted from to run your 101?

From another Victor TT, but I don't know the details, JP responsible for that. 


best-groove's avatar
best-groove
844 posts
 
From another Victor TT, but I don’t know the details

I understand, with this the whole discussion falls away as I have already verified; I don’t think anyone with a cannibalizing engine wants to share even paying his parts with others.
It is a pity.
knollbrent's avatar
knollbrent
526 posts
 
@lewm not vodka, Rum. I’m guessing 101 will be in Miami soon. Each fix JP makes requires a run time. I'm in no hurry. 
More to discover