2. speakers
  3. 1329468063

Amp recommendations for Tannoy Canterbury SE

I have just purchased the Tannoy Canterbury SE speakers and am driving them with my existing Ayon Audio Triton II KT88-based monoblocks delivering 100 Watts per channel. My only source Ayon CD-5 is connected directly to the Ayon monos, since the CD-5 has got a decent volume control. I listen to mostly very fast and dynamic music including rock, techno and others.

My initial impressions are that I am not getting speed, punch and tight bass. I am wondering if this is possibly due to an amp mismatch. While the tube amp's 100 Watts seem more than adequate for Canterburys 8 ohms and 96db spec, I wish I could get better results.

I am seeking recommendations on what could be the best suitable amp for the Tannoy Canterburies. I am open to both tubes and solid state.
- What could be some of the best Tube Amps as well as Solid State Amps that could be a good match ?
- Existing Tannoy Prestige series speaker owners - what amps do you use ?
- Should I be looking at tube amps which are based on tubes other than KT-88 ?

If you have any other recommendations in positioning/configuring the Canterburies please let me know too.

Many thanks in advance
Wilfred
wilfredt
wilfredt OP
36 posts
 
Mulveling, thank you very much for your detailed and encouraging response.

It's a relief to know that a 100 watt tube amp should reasonably drive these speakers. Also good to know that you are running 250 W amps. At one point, I was wondering if I should upgrade to the Ayon Orthos II amps which are 200 watts.

As for tube rolling, I am currently using Shuguang Black Treasure KT88s which are nice and on the warmer side. My amp supports KT88 and KT120 tubes. I want to try KT120 later. Not sure if the EH KT90 tubes you mentioned can work on my amps bcos only KT88 and KT120 is written on the amp. Will need to check with Ayon.

Will try the positioning and variable port tuning as you suggested. I must admit that I haven't yet put them on the pointed footers yet since I am still experimenting with position. I guess putting them on the footer might tighten things up. Will give an update soon.
wilfredt OP
36 posts
 
Goldprintaudio and Musicophile, thanks for your recommendations too.

This tempts me to hook up my previous Nuforce Ref9V3SE amps with the Tannoys to check the results.
Ag insider logo xs@2x
islandmandan
1,260 posts
 
Wilfredt,

The VAC Phi 200, at 100 Wpc in stereo mode, is a direct descendant of the PA 35.35. The layout of the tubes and transformers are identical. They can be used as mono-blocs as well. I bought my VAC right here on A'gon for the nominal sum of $1200. You may consider purchasing a used amp, see if you like it, then move up in the line with new models. For what it's worth, when I talked to Kevin Hayes to thank him for how my amp now sounds, I found out he is very interested in Tannoys, we had quite a discussion about them. He has been using Tannoy Westminster and the Royals ( can't remember rest of their name) at shows lately.

Best of luck, and regards,
Dan
goldprintaudio's avatar
Ag insider logo xs@2x
goldprintaudio
502 posts
 
If you have the Nuforce amps handy, you should try them out for sure. It's worth a shot!
sksos1
388 posts
 
My best friend Kwame has Canterbury SE and has used amps in the 25-35 watts with excellent results. Currently using a Thor 30 watt mono-block that has sounded exceptional. Wonderful speaker.
More to discover