2. misc-audio
  3. 1001256907

Anntenna Question

Hi,

I recently had electricians put a Radio Shack FM antenna on my roof. It's wired with RG-6U cable through a couple of patch panels down to where my receiver is located. Probably about 100' of wire in all.

It doesn't help reception -- in fact, I've gone back to the little wire dipole anenna that comes with the receiver because it sounds better. I put a little Radio Schack antenna amplifier in the mix about 10' from the antenna, and that doesn't help either.

The problem is that I don't know of any way to check whether there's actually a signal on this wire! I have access to bench-quality DVM, but that's about it. Would I require an oscilliscope to check?

I'm also not sure this is the right type of wire, or that I'm hooking it to the receiver correctly.

Any advice appreciated. Thank you!

- Eric
ehart
swampwalker's avatar
swampwalker
5,138 posts
 
Eric- Check your receiver manual if you have it, but I am pretty sure that the 75 ohm tap on the receiver should be connected to the coax, and probably has an F connector for that purpose. If you have one of those "transformers" that comes with a VCR, you can connect that to the end of the coax and then the twin leads of that to the 300 ohm tap on the receiver. If that works, then there is a problem in the receiver with the 75 ohm tap; if it doesn't, then you are probably getting no signal. The first place I would check if that turns out to be the case would be the patch panels (why are they there?).
ehart OP
215 posts
 
Thanks for the tips guys, I will give them a try (additional are welcome of course!).

The patch panel is because I very cleverly (so it seemed at the time) wired my house with RG-6u to every room a few years back (while I was wiring for data).

- Eric
swampwalker's avatar
swampwalker
5,138 posts
 
Eric- do you know if all of in-wall RG6 is intact? Could be your problem, antenna is basically a passive device. BTW, if you are able to get a halfway decent signal with the dipole, then you shouldn't need an amp on the rooftop and signal should be very good (unless you got a directional w/o a rotor).
sugarbrie
3,854 posts
 
Every time you spit a signal it loses strength. If you have the antenna going to every room in the house then the signal is pretty weak in each room. You need a preamplifer once you solve the no signal problem. For televisions a signal split to 2 sets reduces the signal 30%, for 4 sets 60%. FM is a VHF signal so should be the same. Try Stark Electronics in Massachusetts. They are on the web at:


http://www.starkelectronic.com/allamps.htm

celtic66
1,674 posts
 
Eric, Eric.......Eric!!! KISS principle. Purchase a Magnum Dynalab for a C note and be done with this foolishness. The antenna is omnidirectional or turn it horizontal for directional. All done within the confines of your own living room. Excellent sensitivity and selectivity. Best of luck.

Doug
More to discover