Cable Goop Review George is going to freak!!

Hey ozzy the NPS-1260 will be here soon and i was wondering did you use it on the RCA jacks of equipment the cables plug into? Also did use it with usb or anywhere else you would advise? Any warnings you can point out? I thank you for all your input.
   Yes for me there is a big difference with top off of sorcer which is right next to my integrated amp. I am curious if anyone else has same reaction. 

marc777,
I did use the 1260 on a digital rca, just a little on the tip and I also applied it to a F connector for my Satellite connection. Didn't try it on any usb. The 1260 is conductive so it would be too hard to apply in such a close connection point. IMHO that is.
Someday somewhere down the line I do intend in applying it to my  breakers at the box that power my audio.
ozzy

Will treat the interior of my preamp next..then the ac connections and all my outlets on my sound wall and the 3 dedicated breakers and inlet line to the  ac subbox. 
Doing a speaker rebuild will definitely treat all the new lines and connections to and from. The woofer tensile lead maybe a game changer and the solder joints to the voice coil..I may even do the voice coil even though it has enameled wire. Works on soldered connections why not over the enamel even if 25% effective it would be worth the hassle. Tom

theaudiotweak,
Are you buying the stuff by the gallon?

ozzy

The results I have experienced are with a lite coat..not dark not like boot polish. I take the supplied brush and put a drop or 2 on copper foil and then use a artist brush to apply to the parts at hand.
This gives me greater control.
I used the same method with TC.
I also used the supplied stiff narrow fine brush on my dac ribbon cables and those on the transport.  Tom