I'm not sure how to attach pictures to this post to show it
Go to Virtual Systems page, use the "Create System" to upload photos.
https://systems.audiogon.com/
How to repair bottom diaphragm connection of Eminent Technology LFT8 planar speakers
The bottom of the board connecting the wire block came off the printed circuit of the mid range panel diaphragm. Does anyone know how to re-connect or repair this? Can it be soldered back on? I would like to avoid having to replace the entire mid-range panel if possible just for this.
I'm not sure how to attach pictures to this post to show it, but I can send pictures to your email if needed.
I'm not sure how to attach pictures to this post to show it, but I can send pictures to your email if needed.
- ...
- 13 posts total
Thanks. Here is the link to the pictures of the terminal post that came off. https://systems.audiogon.com/systems/9679 |
cgaudio No soldering on this, use car demister paint which is conductive to make the 3 x contacts again, then wrap some sort of stretchy tape around it all to hold it all in place. https://www.ebay.com.au/itm/164396540391?chn=ps&norover=1&mkevt=1&mkrid=705-139619-5960-... Cheers George |
Another option: https://www.amazon.com/gp/product/B00EPYCIGQ/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1 Perhaps, with even better conductivity (more silver): https://www.amazon.com/MG-Chemicals-Conductive-Conductivity-8331D-14G/dp/B08K3TG5D9/ref=dp_fod_1?pd_... Although: if the original connections were soldered; that would be my first choice, for a repair. Desolder the six through-holes, move the contact strip a millimeter or two further up on the diaphragm, to ensure a good contact patch on the (voice coil) traces and resolder through the holes. |
- 13 posts total