Cable Goop Review George is going to freak!!

Has anyone tried this on the solder joints or connections inside of speaker cables or interconnects?  The exterior of these only covers half of the connections at a minimum, correct?  Is there an additional change?
Thanks

..I treated the ribbon pin connectors of both my dac and transport and many fastened connections in my power amps and external power supply. Many of these are similar or the same as those on a speaker's binding posts.
Simple answer is that it makes an improvement wherever applied. 
Materials are suspended in a  conductive polymer which should remain intact for a long time. Tom

..I treated the ribbon pin connectors of both my dac and transport and many fastened connections in my power amps and external power supply. Many of these are similar or the same as those on a speaker's binding posts.
Simple answer is that it makes an improvement wherever applied. 
Materials are suspended in a  conductive polymer which should remain intact for a long time. Tom

tonywinga,
The 1260 appears to remain in sort of an oily state and does not really harden. At least so far with my experience.
My guess is we will move the connectors and then retreat with 1260 far before any possible hardening ever occurs.
You’ll see when you get it tomorrow. You’ll feel like a mad scientist applying a secret substance...LOL!

ozzy

The 1260 showed up yesterday.  I applied some just to my speaker cable spades on the amplifier side- nowhere else at 3 PM.  I let the system warm up for an hour.  I didn’t expect to hear any changes but I did.  I immediately heard a bigger soundstage.  Voices and instruments seem to sound just a bit clearer too.  I put on a Chorale piece that I have listened to many times.  The walls of the Cathedral extended further out. Decays lasted longer.  All this in the late afternoon with the a/c running in the background.  I knew what to play next.  A few weeks ago I was playing Living on the Fault Line. I remember playing the record in my purpose built listening room in the 1990’s and how the reverb or studio echo was almost annoyingly apparent but a few weeks ago I noticed the echo was just barely perceptible.  My room in the 90’s was well isolated and quiet.  My room today is above ground and subject to a higher noise floor- especially during the day.  So I played this record again yesterday and the echo/reverb was more apparent.  This is tangible evidence to me that 1260 did something.  What blows me away is that I still have the other ends of the speaker wires to treat, all of the interconnects and power cords. I can’t imagine what it will sound like after all of that.