Reterminating older MIT 750 CVT Speaker cable to a shorter length - Can this be done?

Thank you gents for the responses. I noticed its only on one of the ends of each cable. These are original MIT 750 CVT factory terminated and has not been tampered with ever.

So shorting the cable from 8 feet to 4 feet on the end without the resistors should be fine I trust?

Thanks

OP it is for a "Transparent cable". I was talking ONLY about the little Hi Pass filter at the end of the run. You can roll it off sooner if you want or leave it out all together. I've made up inline filters that work the same way. You can buy inline filters too.

Honestly though, I quit using all the network cables and went to weaves and ribbon cables. I haven't looked back. 

150.00 is a real push for a pair of 3 meter cables. 1.5 meters 75.00 or so..
They will make the length and use the terminal ends you want too, just ask. It's not a huge store, really kinda of mom and pop..

https://www.ebay.com/itm/203219222929

or

https://www.ebay.com/itm/124663779274.

6 days to 2 weeks. Delivery. I been using the same guy for over 3 years.

Have fun in any case..

Regards

Is that 31 ohm in series?

Or with the capacitor in series between the +/- to roll the high end?

+ to - to roll off above 25K @ 4 ohms I believe. Been 4 years sense I made one up.. They work pretty good. Considering they were 10K + new.

31.7

https://www.instructables.com/How-to-make-a-Transparent-Audio-Reference-XL-Speak/

I made up 10 or 12 pairs. I kept 2. 1 @ 1 meter. 1 @ 3 meters.

You have to increase the hand wound inductor (2.5 mH) in the first part of the network, if you shorten the length. In series on the + leg

Regards