2. cables
  3. 169920-2717

Tornado and Thunder Power Cables

Hi all,

I am going to be upgrading my power cables for my preamp, 2 channel power amp and 5 channel power amp and I have chosen the following power cables to use in my setup:

1m Tornado(source)- preamp
2m Tornado(high current)- 2 channel power amp
1m Tornado( high current)- 5 channel power amp

In terms of bringing the cost down, if I used a 1m Thunder power cable for the 5 channel amp instead of the 1m Tornado(high current) would I be missing anything sonically by not using a Tornado HC power cable? Does anyone in the forum have a similar setup or are using a Thunder HC power cable as well mixed with the Tornado power cables? If so, what are your thoughts? Would it be better to just keep it all the same brand of power cable consistent or is there a huge sonic difference between the two power cables that would warrant me to stay with the Tornado HC power cable for my 5 channel amp?

Thank you in advance for your thoughts. Much appreciated.

2007audioman

2007audioman
bewgow
65 posts
 
It may be relevant to specify what preamp and poweramp you are using?
2007audioman OP
80 posts
 
@bewgow. See below:

Preamp- Marantz AV8805
Power amp(2 channel)- Rotel RB1590
Power amp(5 channel)- Rotel RMB1585

Thanks bewgow.
riley804
1,224 posts
 
Power amp(2 channel)- Rotel RB1590
Power amp(5 channel)- Rotel RMB1585

Rotel amps are definitely not one that is recommended for 2 channel listening .   tend to be be cold / sterile sound and give the listener fatigue.
seems you are trying to make a sub par amp better by putting an expensive power cord on it.

if you want better 2 channel sound, then i would look at getting a preamp with home theater bypass and a better 2 channel amp.
More to discover