Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

rwpollock - which model Ansuz cables are you referring to that you place as your first preference.

I have C2 level Mainz Power Distributor and C2 Mainz power cables. Have always been tempted by their speaker cables but seem to think (from what I've read and researched) that their power products are the sweet spot in their lineup.

Re the Ansuz cables, I have a set of D1 which, given the improvements from the 1 generation to the 2 generation, may be equivalent to the C2 level. Agreed that their power products are the place to go; I bought their other wires in a package deal I couldn't refuse from someone who was upgrading at the time.

At a lower price point I would certainly recommend the LessLoss products; Atelier 13 in Nashville offers a loaner two-week home trial. The package contains an assortment, but once again power is the ruler.

- Robert

BTW I should make clear that my previous post regarding sub woofing the Nens is not meant to be a blanket recommendation to do same.  My set up puts the speakers far from corners, sidewalls and front wall (to emphasize breadth and depth of soundstage) and my ceiling height is over 20'.  So there is little ambient base reinforcement which accounts for the KEF KC62 making a more positive impact than it might in another set up.  And I meant 60Hz not 60db for crossover.

Is anybody using a SET 300B amp (~8W) on the Nenuphar listening to large orchestral classical music? 

Is that expected to work well in a 12x18ft room (4mx6m)?

@mga71 I believe I’ve posted on this before (if memory serves). IF NOT, here goes:

With this version* of the F10 Neo drivers: it is my opinion, based on two and a half years of personal experience, that the power output from a 300B SET amp is in the "ideal range" to drive the Nenuphars (F10 Neo + TQWT enclosure).

I continue to be surprised that owners have not used 300B SET amps to drive the Nenuphars. Even if I ignore [IMO] the "ideal power output synergy", the far wider numbers and brand options available (versus other SET types), the spread of options over a wide price range, the healthy used market, all point to a higher probability match.

My previous 2A3s were purposely designed to output 4 Watts. My current 2A3s are purposely designed to output 3 Watts. In both cases, my percentage of large scale orchestral music listening has increased. Note: this is also due to and dependent of other system based changes.

My room is 19 ft wide (front wall) by 26 ft long by 9 ft tall.

Given what I’m hearing across a fairly wide range of music genres, for my preferences and needs AND room size, I would not want to go below 3 Watts. Again, this is for a very wide range of genres. If someone is focused on smaller scale acoustic genres, then lower output power will be fine.