Noise/distortion coming out of speakers

I think your amp has a sealed volume control. There are other problems that could cause noise while adjusting the volume. Check with the manufacturer before attempting any DIY methods.

nothing wrong w Mofimadness' advice. if its a sealed unit its probably the only thing you can do, short of sending it out for service. It cannot hurt to try the rapid rotation method, AS LONG as the unit is turned off.

Nothing wrong with Mofimadness' advice except it's not a cure. The problem will soon return and as it returns the sound is degrading. I tried the rapid rotation method on a preamp and the volume pot eventually froze up and needed to be replaced anyway. A quality properly operating volume pot is a key element to good sound.

Rrog, you're right. I also found rotating pot a temporary remedy on my Benchmark DAC1 volume control. I used contact cleaner/fader lube and so far it is completely silent for three years.

If this is happening while you're changing the volume from your remote, the noise be caused by the little motor that is moving it, if it just happens with the remote.

I've seen some new upper-end units do this, while some cheap ones don't. It depends on the design. You could ask the company if this is normal while using the remote. If it did this since new, it just may be its design. The motor doesn't do anything (add noise), when all is well, while playing music at a fixed level.

If it does it while changing it manually by the knob, then the volume potentiometer most likely is the problem. It could be adding some noise that may not be really noticeable now. But, it can worsen, if this is the case.