LSA Voyager GAN Amplifier

Would there  be harmonic distortion from a 15khz tone that humans could hear or a band limited amp would amplify? Anyway this Voyager amp uses 2 stereo modules bridged which doesn't make sense to me, I think one could find a better amp for less mony.

It’s not. And that’s what confuses people with no hands on experience. I read that thread over on ASR and the answers from the armchair engineers were to increase the bandwidth so harmonics out of the band of human hearing would tell us what was needed to know. Poor answer. That wouldn’t tell us any meaningful information.

What the 15khz test tone could potentially do is put strain on the amp, which in turn worsens the harmonics from the 1khz test tone. As well as increase the noise floor of the amp. Because performance within the audible band is what audiophiles care about. But some folks must only listen to music where all the tones are at 1khz. So this test would be meaningless for them.

What the 15khz test tone could potentially do is put strain on the amp, which in turn worsens the harmonics from the 1khz test tone. As well as increase the noise floor of the amp. Because performance within the audible band is what audiophiles care about. But some folks must only listen to music where all the tones are at 1khz. So this test would be meaningless for them.

🤦‍♂️🤦‍♂️🤦‍♀️

Lol! This statement suggests that your analyzer isn't being run properly or its broken. 

Funny it runs properly when I use the Mundorf resistor based dummy load. I guess the analyzer must have a brand bias. 

To be clear, the conclusion isn’t supported by the opening statement. You don’t know anything about me

This isn’t about you. It’s about the specs of the analyzer you claim to own. Unless the manufacturer is lying. There's been some innovations in this field since 1982.