Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure


Cube Audio (Poland) designs single drivers and single driver speakers. 

Principals are Grzegorz Rulka and Marek Kostrzyński.

Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page: 

https://www.cubeaudio.eu/cube-audio-nenuphar

Link to 6Moons review by Srajan Ebaen (August 2018):

https://6moons.com/audioreview_articles/cubeaudio2/

----------------------------------------

Parameters (from Cube Audio):

Power: 40 W

Efficiency: 92 dB

Frequency response: 30Hz - 18kHz ( 6db)*

Dimensions: 30 x 50 x 105 cm

Weight: 40 Kg


* Frequency response may vary and depends on room size and accompanying electronic equipment.
david_ten

Here's some images/layout of the space. I have some other furniture in the room and a large area rug. I can't reconfigure the space (WAF). I've moved the speakers as wide as possible and as close, forward and back. I get some different results on different tracks but vocals tend to always be left sided. Being this is technically a dining room there is a cut out for hutch, which is where my equipment cabinet is. It's about 8' wide and 1' recessed. I wonder if that is creating some issues in the room, as well as the window area.

floorplan

 

floorplan3d

@abd1  We are out the door headed to the beach. In Florida for a short break. I'll respond once we are back inside this evening. 

Your layout pics are super helpful. Hopefully, others will offer their perspectives and advice.

FYI dimensions are approximate but pretty close. Picture also depicts two subs but I'm only using 1 right now.

abd1, I understand your frustration. This is my opinion but when I had the Acoustic Zen Crescendos that have a wide dispersion ribbon tweeter, the vocals where better focused in the the center most of the time. The Cubes speakers don’t have a ribbon tweeter but have many other significant advantages as a full range single driver loudspeaker. In my set-up I struggled with the same issue to a lesser extent. When I replaced my QNAP NAS drive with an AfterDark Roon Server, replaced my component isolation, lowered the noise floor by adding ac filtration, and added Stilpoint Apertures, the center fill improved greatly. I have my Nenuphars with 5 degrees of toe in, 11” from the front wall, 91” apart and I sit 10’ from the front baffle in a 15’ wide room open to a kitchen area. I’m going to point out the elephant in the room now. You have a difficult room to work with. The side wall(s) first reflections are asymmetrical and your room closely resembles a square. If you could position you system (speakers and electronics) in the bay window area, that would be more ideal but impractical. If you have a basement below the room, then you could locate your electronics down there while leaving your speakers in the bay window area. Before doing all of that, I would try David’s set-up and toe the speakers in so they intersect in front of your listening position.