Use an amount that does not give you distortion in the R channel (too little) or in the L channel (too much) and does not result in a deviated cantilever after several hours of play. And then, forgeddaboudit.
A new way of adjusting anti skate!
I was looking at the Wallyskater, a $250 or so contraption used to set anti skate. https://www.wallyanalog.com/wallyskater It is reputedly the most accurate way to set anti skate. Talking about fiddly.
The appropriate figure is 9 to 11 percent of VTF. So if you are tracking at 2 grams you want 0.2 grams of anti skate.
My Charisma tracks at 2.4 grams so I should set the anti skate for 0.24 grams..................................Bright light!.
I readjusted the Syrinx PU3 to zero so that it was floating horizontally. I set up a digital VTF gauge on it's side at the edge of the platter so that the finger lift would be in the cross hairs, activated the anti skate and was easily able to adjust it to 0.24 grams. I started at 0.18 grams and just added a little more. Whatever you measure the anti skate from it has to be at the same radius as the stylus. If you do not have a finger lift at the right location you can tack a toothpick to the head shell and measure from that. As long as you have the whole affair balanced at zero you will be fine. Added cost $0.00 as long as you have a digital VTF gauge.
I would not buy stock in Wallyskater.
The appropriate figure is 9 to 11 percent of VTF. So if you are tracking at 2 grams you want 0.2 grams of anti skate.
My Charisma tracks at 2.4 grams so I should set the anti skate for 0.24 grams..................................Bright light!.
I readjusted the Syrinx PU3 to zero so that it was floating horizontally. I set up a digital VTF gauge on it's side at the edge of the platter so that the finger lift would be in the cross hairs, activated the anti skate and was easily able to adjust it to 0.24 grams. I started at 0.18 grams and just added a little more. Whatever you measure the anti skate from it has to be at the same radius as the stylus. If you do not have a finger lift at the right location you can tack a toothpick to the head shell and measure from that. As long as you have the whole affair balanced at zero you will be fine. Added cost $0.00 as long as you have a digital VTF gauge.
I would not buy stock in Wallyskater.
- ...
- 98 posts total
@lewm I still not get it how the OP goes about doing this floating arm. Is he attaching some kind of string to the headshell and then zeroing the digital scale with no AS and go from there? I use Analogmagic as my baseline, then move from there. I believe that with either the Wallytractor (which has the limitation of not having all the spindle to pivot arches) or the Smarttractor and Analogmagic I can set the cartridges very easily and precisely. what are your thoughts? |
- 98 posts total