Silver v Copper wire phono cable


Getting ready to order new tonearm, have option for either copper or silver continuous phono cable from cartridge to preamp.  without the  opportunity to compare personally, I would like to hear how others would chose....my system is shown on this site...thank you

J

128x128jw944ts

I don’t think so. When a good silver wire causes the sonic balance that you are suggesting, the problem would most likely be that the rest of the system is too tipped up in balance.

@best-groove 

From your emoji I assume you have very good teeth.

Do you floss with silver wire as well.

 

 

Do you floss with silver wire as well.

 

not, silver I only have a couple of old doubloons. 

 

@jw944ts - cable selection is far more complex than Silver vs. copper and it seems that cable geometry and insulation type are seldom mentioned.

However, as pointed out by others, these two design elements of a cable are most often responsible for the negative comments (e.g. harsh sounding) that arise when people listen to Silver cables.

This is because they account for much of the distortion that occurs within the cable itself - even at the very low voltage levels of a phono cable

But I hasten to add, I am not disputing the claims that a specific Silver Cable did not sound as nice as a Copper Cable, but the selection of the right cable is far more complex than simply its metallurgy.

So, how can a person make a sound choice?

  • by becoming aware of cable construction techniques, e.g.
  • Silver offers the fasted dynamic performance of all metals and as such will provide the very best perofrmance WRT clarity and details and both of these attributes are paramount in a wire that carries the most delicate signals in the audio chain.
  • Insulation can create distortion in the signal
  • cable geometry also has an impact on distortion within a cable

Companies like Zavfino, In-Akustik, Nordost, Cardas (among others) are very aware of the impact that metal, Insulation type and cable geometry has and go to great lengths to mitigate noise/distortion by combining them effectively.

So, for the "average consumer". I would recommend looking into offerings from those companies (and some of the other in the above posts) and consider their cable design, much more that simply comparing the metallurgy

BTW - I have the Cardas Silver one piece harness and am extremely happy.

Regards - Steve

Dear @williewonka  : Till you test the AN silver cable you will know for sure what fogman is talking about. Your Cardas is not at the same quality level performance than the AN. You only have to test to confirm my statements.

 

R.