What year did you buy the Carver Crimson 275 amplifier?
As for ’ your ’ Carver Crimson 275 amplifier did you remove the bottom cover and actually look inside the amp? The photo you posted was not of your amp.
It is possible your amp may be wired differently than the one shown in the photo.
(Note: The photos I posted were from the same Web Site as the one you posted)
From what I have read Bob Carver only designed the Carver Crimson 275 amplifier. He had nothing to do with its production. I doubt if Carver had any say in the quality of components used in the amp.
I doubt if Frank Malitz did either.
Who knows who actually assembled(s) and wires the amp. Is it farmed out?
It would help to know for sure if ’your’ amp is wired the same as the one in the photo. Good chance the IEC ground pin is not bonded, connected, to the chassis. Carver’s schematic wiring diagram only shows the AC source symbol. Typically a picture of an AC plug, be it a 2 pole only, (no EGC), or a 2 pole with ground pin for a EGC will be shown. Carver may not have wanted an EGC to be used. But that doesn’t mean he wanted a 3 pin IEC inlet connector installed on the amp. A two pin IEC would have been the correct IEC connector to use. Carver was out of the loop...
Who owns and runs Bob Carver Corporation.
What I would like you to look for is how the IEC power inlet connector is wired. Is it wired exactly as the amp shown in the photo you posted?
FYI, Before you remove the bottom cover, for your safety, unplug the amp from the wall outlet. If the amp was on before you start removing the bottom cover then wait about an hour before removing the cover. That will allow the electrolytic caps to bleed off the high B+ DC voltage.